Instructions:

1. Remove the test panel from the foil pouch.

2. Pull off the protective cap to expose the absorbent tip.

3. Collect urine in a clean, dry container and dip the absorbent tip vertically into the urine for about 10–15 seconds.
   Note: Do not allow urine to pass above the arrow mark on the test device.

4. Remove the test from the urine and place it on a flat, dry surface. Start a timer and read the result within 5 minutes.
   Do not read the result after 10 minutes.

Result interpretation:

• NEGATIVE: Two lines appear. One red line should be in the control region (C), and another clearly visible red or pink line in the test region (T). This indicates drug concentration is below detectable level.
  Note: The shade of red in the test region (T) may vary, but even a faint pink line is considered negative.

• POSITIVE: One red line appears in the control region (C). No line appears in the test region (T). This indicates drug concentration is above detectable level.

• INVALID: Control line does not appear. This is most likely due to insufficient sample volume or incorrect procedure. Review the procedure and repeat the test with a new strip. If the problem persists, contact your local supplier.