Instructions for use:

1. Remove the test panel from the foil pouch.

2. Pull off the protective cap to expose the absorbent tip.

3. Collect urine in a clean, dry container and dip the absorbent tip vertically into the urine for about 10–15 seconds.
   Note: Do not allow urine to go above the arrow mark on the test device.

4. Remove the test from the urine and place it on a flat, dry surface. Start a timer and read the result within 5 minutes.
   Do not read the result after 10 minutes.

Result interpretation:

• NEGATIVE: Two lines appear — one in the control region (C), and one in the test region (T). This indicates the drug concentration is below the detectable level.
  Note: The shade of red in the test region (T) may vary, but even a faint pink line indicates a negative result.

• POSITIVE: One red line appears in the control region (C). No line appears in the test region (T). This indicates the drug concentration is above the detectable level.

• INVALID: No control line appears. This is most likely due to insufficient sample volume or incorrect procedure. Review the procedure and repeat the test with a new strip. If the problem persists, contact your local supplier.

The test is CE marked.