Cannabis Test – Cut off: 20 Ng/ml

How long can cannabis be detected with this test?

• Up to approx. 4 days with single intake
• Up to approx. 10 days with sporadic intake
• Up to approx. 8 weeks with daily intake

Procedure
1. Remove the test panel from the foil pouch.
2. Peel off the protective sleeve to expose the absorbent part.
3. Collect urine in a clean, dry container and immediately dip the test stick’s absorbent strip vertically into it. Leave in the urine for approximately 10-15 seconds. NOTE! The urine must not pass over the „arrow mark“ on the test device.
4. Remove the test device from the urine and place it on a flat, dry surface. Start the timer and read the result within 5 minutes. NOTE! Do not read the result after 10 minutes.

Interpretation of results:
NEGATIVE:* Two lines appear. One red line should be in the control region (C), and an
adjacent, clearly red or pink line should be in the test region (T). This negative result
indicates that the drug concentration is below the detectable level.
*NOTE: The shade of red in the test region (T) may vary, but the test should be considered
negative if there is even a faint pink line.

POSITIVE: A red line appears in the control region (C). No line appears in the test region
(T). This positive result indicates that the drug concentration is above the detectable level.

INVALID: The control line does not appear. Insufficient sample volume or incorrect procedure are
the most likely reasons for the control line not appearing. Review the procedure and
repeat the test with a new test strip. If the problem persists, discontinue the procedure and contact
your local supplier.

The test is CE marked.

Instructions for Use (PDF)