Name: Urine Drug Test Multi 12-Panel
Brand: Safecare
SKU: 111032
Availability: InStock

Urine Drug Test Multi 12-Panel

€16.57

Excl. VAT

A drug test that detects traces of 12 substances in urine. One of our best drug tests, specially developed to detect certain pill-based drugs, but also to trace the most common drugs. Our Multi 12-Panel Drug Test is easy to use and delivers results within minutes.

SKU: 111032 Category: Multi Drug Test

Brand: Safecare

Art.no : 111032

This urine test detects 12 common drugs. A multi-test is good if you are unsure of what drugs the test person uses and is accustomed to. The test works by dipping a test stick into a cup of collected urine and then reading the result on the test device.

Cut-off:

Cannabis (THC) 50 ng/mL
Cocaine (COC) 300 ng/mL
Methamphetamine (MET) 1000 ng/mL
Buprenorphine (BUP) 10 ng/mL
Oxycodone (OXY) 100 ng/mL
Opiates (OPI) 2000 ng/mL
Methadone (MTD) 300 ng/mL
Tramadol (TML) 100 ng/mL
Benzodiazepines (BZO) 300 ng/mL
Amphetamine (AMP) 1000 ng/mL
Methylenedioxymethamphetamine, Ecstacy (MDMA) 500 ng/mL
Ketamine (KET) 1000 ng/mL

Procedure
1. Remove the test panel from the foil pouch.
2. Peel off the protective sleeve to expose the absorbent part.
3. Collect urine in a clean, dry container and immediately dip the test stick’s absorbent strip vertically into it. Leave in the urine for approximately 10-15 seconds. NOTE! The urine must not pass over the “arrow mark” on the test device.
4. Remove the test device from the urine and place it on a flat, dry surface. Start the timer and read the result within 5 minutes. NOTE! Do not read the result after 10 minutes.

Interpretation of results:
NEGATIVE:* Two lines appear. One red line should be in the control region (C), and an
adjacent, clearly red or pink line should be in the test region (T). This negative result
indicates that the drug concentration is below the detectable level.
*NOTE: The shade of red in the test region (T) may vary, but the test should be considered
negative if there is even a faint pink line.POSITIVE: A red line appears in the control region (C). No line appears in the test region
(T). This positive result indicates that the drug concentration is above the detectable level.INVALID: The control line does not appear. Insufficient sample volume or incorrect procedure are
the most likely reasons for the control line not appearing. Review the procedure and
repeat the test with a new test strip. If the problem persists, discontinue the procedure and contact
your local supplier.